东莞市锋彦达生活科技有限公司
新闻动态
ELASTOSIL® LR 3003/20 TR A/B
来源: | 作者:agriculture-100 | 发布时间: 2024-06-11 | 88 次浏览 | 分享到:
LR 3003

 Regulatory Product Information

ELASTOSIL® LR 3003/20 TR A/B RoHS (Restriction of Hazardous Substances) None of the substances mentioned in Directive 2011/65/EU (RoHS), including subsequent  amendments e.g. Directive 2015/863/EU, are intentionally introduced. Therefore they are not  expected to be present in amounts exceeding the defined limit values.

 WEEE (Waste of Electrical and Electronic Equipment) None of the substances mentioned in Directive 2012/19/EU (WEEE) are intentionally introduced  during manufacture. Therefore they are not expected to be present except for trace amounts from  incidental environmental contamination. Analytical data is not available. Heavy Metals Directive 94/62/EC (Packaging and packaging waste) CONEG (Coalition of Northeastern Governors) Directive 2000/53/EC (End-of life vehicles) None of the substances concerned (lead, chromium VI, cadmium, mercury) are intentionally  introduced. Therefore they are not expected to be present except for trace amounts from incidental  environmental contamination. Analytical data is not available.

 REACH SVHC (Substances of Very High Concern) Please see Safety Data Sheet. Allergens Regulation (EU) No 1169/2011, substances listed in Annex II Substances listed in the Food Allergen Labeling and Consumer Protection Act (FALCPA) Latex Fragrances The substance(s) mentioned above are not used in the manufacture or the formulation of this product.Regulatory Product Information for ELASTOSIL® LR 3003/20 TR A/B / Version: 1.12 / Date of last alteration: 07/28/2023 / Date of print: 06/11/2024 2 / 5

GMO (Genetically Modified Organisms) Product is not derived from genetically modified organisms and for its manufacture no intermediates  and/or auxiliary agents which are genetically modified are used. BSE/TSE The product is not derived from human or animal origin and for its manufacture no intermediates  and/or auxiliary agents which are of human or animal origin are used.


 Food Contact Regulations Europe Regulation (EC) No 1935/2004 Provided appropriate processing, the product is suitable for the manufacture of food contact materials  and articles according to article 3 of this Regulation, insofar as it is of suitable purity and not  hazardous according to European classification and labelling requirements. Compliance with the requirements of Regulation (EC) No 1935/2004, especially the suitability of the  material or article for the intended use, the observance of any given limitations, the effect on taste and  smell of the food has to be ensured by the producer of the finished food contact material or article as  it is placed on the market. Regulation (EU) No 10/2011 Not applicable. Silicones are exempted from this Regulation. Regulation (EC) No 2023/2006 Not applicable. This product is considered as a starting material and therefore out of the scope of this  Regulation. Germany Recommendation of the BfR XV. Silicones The ingredient(s) of this product are in compliance. Limitation(s): Volatiles max. 0.5%. Extractable  substances: max. 0.5%. France Arrêté du 25 novembre 1992 The ingredient(s) of this product are in compliance. Limitation(s): Overall migration from the final  article must not exceed 10 mg/dm² or 60 mg/kg. Volatiles max. 0.5%. Spain Royal Decree 847 of July 2011 The ingredient(s) of this product are in compliance. Limitation(s): Overall migration from the final  article must not exceed 10 mg/dm² or 60 mg/kg. SwitzerlandRegulatory Product Information for ELASTOSIL® LR 3003/20 TR A/B / Version: 1.12 / Date of last alteration: 07/28/2023 / Date of print: 06/11/2024 3 / 5 Swiss Ordinance SR 817.023.21 The ingredients of the product are listed in annex 9. USA The product is suitable for use under the following section(s) of Title 21 of the Code of Federal  Regulations and those which refer to these: §177.2600 RUBBER ARTICLES INTENDED FOR REPEATED USE; Extraction limits must be met  on the finished article per 177.2600 (e) & (f). §175.300 RESINOUS AND POLYMERIC COATINGS; Extractive limits under (c) - (e) on finished  article China Standard GB 9685-2016 The contained additives are listed in table A.3 or A.7 for rubber or silicone rubber, respectively. The  platinum catalyst is considered as NIAS for which a migration limit of 0.01 mg/kg food or food simulant  applies. Standard GB 4806.11-2016 The siloxane based starting substances are listed in Table A.2. Standard GB 4806.1-2016 General safety requirements The product meets all applicable requirements of this Standard insofar as it is not classified as  hazardous to human health according to the European classification and labelling requirements. Brazil/Mercosur States The base polymers are in compliance with the positive list of starting materials for the manufacture of  silicone elastomers under RDC N° 123 of June 19, 2001. The base polymers and fillers are listed in  RDC N° 56 of 2012 and/or GMC RES N° 28/99. Limitation(s): A platinum catalyst is already contained. The limit for platinum has to be observed: A maximum of 50  mg/kg platinum (catalyst residue) may be detected in the finished product. Overall migration from the finished article may not exceed 8 mg/dm² or 50 mg/kg food. Please note: Unless otherwise stated, no additives/components with an SML are used. Regulatory sanctioning of the ingredients in a product does not imply that the finished product  manufactured from those ingredients is considered safe for contact with food by regulatory bodies. Regulatory Product Information for ELASTOSIL® LR 3003/20 TR A/B / Version: 1.12 / Date of last alteration: 07/28/2023 / Date of print: 06/11/2024 4 / 5 The responsibility for compliance of the finished article and any testing requirements relating to  migration, extraction or volatile limits resides with the manufacturer of the finished product.

Toy Regulations DIN EN 71-3 Substances mentioned in DIN EN 71-3:2019, table 2 are not intentionally introduced. Therefore they  are not expected to be present except for trace amounts from incidental environmental contamination.  Analytical data is not available. DIN EN 71-9 Substances mentioned in DIN EN 71-9:2007, tables 2A – 2I are not intentionally introduced.  Therefore they are not expected to be present except for trace amounts from incidental environmental  contamination. Analytical data is not available. CPSIA (Consumer Product Safety Improvement Act) of 2008 None of the substances concerned (lead, phthalates) are intentionally introduced. Therefore they are  not expected to be present except for trace amounts from incidental environmental contamination.  Analytical data is not available.

Substances PAH (Polycyclic aromatic hydrocarbons) DMF (Dimethylfumarate) APEO (Alkylphenol ethoxylates) Phthalates Azo compounds PCDD/PCDF (Polychlorinated dibenzodioxins and dibenzofurans) Asbestos Melamine BPA (Bisphenol A), BPS (Bisphenol S) Radioactive substances PFOS (Perfluorooctane sulfonate), PFOA (Perfluorooctanoic acid) POP (Persistent organic pollutants) as defined in Regulation (EU) 2019/1021 (Stockholm  Convention) Conflict minerals as defined in section 1502(e)(4) of H.R. 4173, of the Wall Street Reform and  Consumer Protection Act ODS (Ozone Depleting Substances) as mentioned in Regulation (EC) No 1005/2009 SCCP (Short-chain chlorinated paraffins) The substances mentioned above are not intentionally introduced. Therefore they are not expected to  be present except for trace amounts from incidental environmental contamination. Analytical data is  not available.

 Irradiation Product does not undergo any form of radiation treatment.Regulatory Product Information for ELASTOSIL® LR 3003/20 TR A/B / Version: 1.12 / Date of last alteration: 07/28/2023 / Date of print: 06/11/2024 5 / 5

Chemical Inventory Status See Safety Data Sheet.


 Certificates Available Certificates can be downloaded via  https://www.wacker.com/cms/de/wacker_group/wacker_facts/ims/certificates/certificates.jsp This document was created electronically and does not require a signature

新闻分类